← Back to Project mkstick

Format the stick

Wipe the stick and set it to FAT32 on Windows, Mac or Linux. Needed if the page says the stick is not empty.

Project mkstick only writes to an empty FAT32 stick. If the page says the stick already has files, or the stick will not open, format it first.

This erases the stick Formatting wipes everything on the stick. Copy off anything you want to keep, and check you have picked the stick and not another drive.

If the stick has been giving errors, eject it, unplug it and plug it back in before you start.

Windows#

  1. Open File Explorer, right-click the stick and choose Format.
  2. Set the file system to FAT32 and press Start.
  3. If FAT32 is not in the list, which happens with sticks over 32 GB, open Command Prompt and run the line below. Change E: to the stick’s letter. This needs Windows 11 version 24H2 or later.
format E: /FS:FAT32 /Q

Mac#

  1. Open Disk Utility and choose Show All Devices from the View menu.
  2. Select the stick itself, which is the top entry rather than the volume under it, and press Erase.
  3. Set the format to MS-DOS (FAT) and the scheme to Master Boot Record, then press Erase.

Linux#

  1. Open Disks, select the stick and choose Format Disk with MBR partitioning.
  2. Add one partition of type FAT.
  3. Or use a terminal, changing sdX1 to your stick’s partition:
sudo mkfs.vfat -F 32 /dev/sdX1

Then go back to the page and choose the stick again.